Monday, August 29, 2011

Look Ma, no work table!

Click on image to enlarge

This was a big weekend as I was able to remove my fuselage from my work table. I flipped it upside down so that I could finish installing rivets on the underside of the belly skin. These are the rivets that you are not able to get at because of the jigging.


Before I flipped over my project, I cut the exit slots for the rudder cables where they come out of the fuselage in the rear.


Above I am attaching the belly skin to the center section.


Now I'll work on installing the forward bottom skins and install the tail wheel before I flip it over.

No comments:

Post a Comment